Dewalt Portable Forced Air Electric Heater, DXH2003TS

Dewalt portable forced air electic construction heater, 68,242/44,357 Btu., F340655
Manufacturer part number: DXH2003TS
$1,039.00

DeWALT Portable Forced Air Electric Construction Heater: DXH2000TS

 The thermostatically controlled DXH2003TS two stage electric heater operates at 20,000 watts on a 240v three phase circuit. As a convenience, this heater can also be used at 13,000 watts with the flip of a switch. Constructed with dual coil supports oversized ergonomic handle, included wheel kit and very durable jobsite construction.

 

  • Two stage Operation - Connects to either a 100A or 60A breaker. 100A service provides high or low heat outputs.
  • Equipped with a 25°F-95°F thermostat. The heating element cycles on and off to maintain the set temerature.
  • Designed and certified as an unattended source of jobsite heat.
  • Recessed controls designed to reduce the risk of damage on the jobsite.
  • Burner coils are supported at both the top and bottom to reduce transport noise and provide extra support for increased coil life.
  • Fan only setting for circulating air on the jobsite.
  • Output: 68,242 / 44,357 Btu/hr.
  • Amps: 50 / 33 A
  • Minimum Breaker Required: 3-Pole 60A @ 20KW / 3-Pole 40A @ 13KW
  • Three Phase
  • Watts: 20,000 W
  • Output (CFM):  600 CFM
  • OUtput: 20KW
  • System 240V
  • Weight:   48 lbs.

Currently only shipping this item within the 48 contiguous United States.

DeWALT Portable Forced Air Electric Construction Heater: DXH2000TS

 The thermostatically controlled DXH2003TS two stage electric heater operates at 20,000 watts on a 240v three phase circuit. As a convenience, this heater can also be used at 13,000 watts with the flip of a switch. Constructed with dual coil supports oversized ergonomic handle, included wheel kit and very durable jobsite construction.

 

  • Two stage Operation - Connects to either a 100A or 60A breaker. 100A service provides high or low heat outputs.
  • Equipped with a 25°F-95°F thermostat. The heating element cycles on and off to maintain the set temerature.
  • Designed and certified as an unattended source of jobsite heat.
  • Recessed controls designed to reduce the risk of damage on the jobsite.
  • Burner coils are supported at both the top and bottom to reduce transport noise and provide extra support for increased coil life.
  • Fan only setting for circulating air on the jobsite.
  • Output: 68,242 / 44,357 Btu/hr.
  • Amps: 50 / 33 A
  • Minimum Breaker Required: 3-Pole 60A @ 20KW / 3-Pole 40A @ 13KW
  • Three Phase
  • Watts: 20,000 W
  • Output (CFM):  600 CFM
  • OUtput: 20KW
  • System 240V
  • Weight:   48 lbs.

Currently only shipping this item within the 48 contiguous United States.

Product tags